Operating Instructions; Operating Tips And Maintenance - Blue Clean AR 383 Manual Del Proprietário

QC - Clear
Adapter
Garden Hose
Adapter (GHA)
Fig. 11
Fig. 12
(GHA)
Fig. 14
Fig. 13
ON
OFF
Fig. 15 Fig. 16
Trigger
Fig. 17
Garden Hose Adapter
• Install the garden hose adapter (GHA) and quick connect
filter. It is made up of two separate pieces. (1) A clear plastic
adapter with a screen filter (about 3 inches long) and (2) a
blue/black collar attachment (Fig. 11).
• First, remove the plastic shipping cover on the water inlet on
the front of the power washer. Attach the clear plastic adapter
by screwing it into the water inlet (Fig. 12). Hand tight is
fine. Next screw on the blue/black collar attachment to your
garden hose (Fig. 13). Slide the blue/black collar onto the
clear adapter (Fig. 14), it will "click" into place. The water is
now connected to your power washer.
• To remove the water hose, simply pull back on the blue collar
and it will slide off the clear adapter. Note: this can be done
at any time. Water will not come out of the garden hose as
the blue/black collar has a water check valve. Water will only
flow from the garden hose when it is connected to the clear
adapter.
• You have now completed the assembly of your BLUE
CLEAN POWER WASHER and are now ready to begin using
your electric power washer. Read and observe all safety
instructions.
o i
Perating nstrUctions
• Turn on the water supply at the faucet.
• Make sure the "ON/OFF" switch is in the "OFF" position. The
power switch has international symbols for 'on' and 'off': On
(--) Off (O). (Fig. 15)
• Unwind the power cord completely and plug the GFCI into a
grounded 120 volt outlet. (Fig. 16).
• Release the safety lock button on spray gun (Fig. 17) while
pointing the spray gun in a safe direction, away from yourself
and others squeeze the trigger on the spray gun until there is
a steady stream of water, letting the water and air out of the
hose.
• Press the 'ON' button. The motor and pump should now be
running and providing a powerful spray.
o t
Perating
• If you hear the motor run intermittently when the trigger is not
being squeezed, that is normal. The pump is priming itself so
it is ready to operate when the trigger is squeezed. Turn off
the power washer if not being used after five minutes.
• The o-rings on the bayonet end of the adjustable lance and
detergent bottle should be cleaned regularly and lubricated
m
iPs and aintenance
En - 9