Yealink SIP-T48S Guia De Inicio Rapido página 7

Configuring Your Phone
Configuring via web user interface
Accessing the web user interface:
1. Press the OK key when the phone is idle to get the IP address of the phone.
2. Open the web browser of your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10" or "192.168.0.10"), and
then press the Enter.
3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm.
Network Settings: Click on Network->Basic->IPv4 Config
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid network settings, e.g., IP address,
subnet mask, gateway address and DNS address.
Static IP Address: If your phone cannot contact a DHCP server for any reason, you need to configure the IP address, subnet mask, gateway
address, primary DNS address and secondary DNS address for the phone manually.
Note: The IP phone also supports IPv6, but IPv6 is disabled by default.
The wrong network settings may result in inaccessibility of your phone and may have an impact on the network performance.
Contact your system administrator for more information.
Account Settings: Click on Account->Register->Account X (X=1,2,3...15,16)
Parameters of the account:
Register Status:
Line Active:
Label:
Display Name:
Register Name:
User Name:
Password:
Server Host:
Register status icons on the touch screen:
(Green) Registered
Note: Check with your system administrator if any error appears during the registration process or if a specific configuration is required
for your registration.
Configuring via phone user interface
Network Settings:
When the phone is idle, tap
NAT to configure the network.
Account Settings:
When the phone is idle, tap
Note: For more information on account parameters, refer to Configuring via web user interface above.
It shows the register status of the current account.
You can select Enabled/Disabled to enable/disable the account.
It is shown on the touch screen to identify the account.
It is shown as Caller ID when placing a call.
It is authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
(Gray) Register Failed
->Advanced (default password: admin)->Network->WAN Port/VLAN/Web Server/802.1x/VPN/ LLDP/ CDP/
->Advanced (default password: admin)->Account to configure the account.
(Green and Flashing) Registering
E
N
G
L
I
S
H
3