Transport And Storage - VOSS.farming easyCUT 85285 Instrucciones De Operación

Fault /Problem
Clipper head gets
very hot
Blades cut badly
Blades do not cut
11

TRANSPORT AND STORAGE

WARNING
► Before storage, make sure that the unit is disconnected from the power
supply.
► Store the machine in an environment that is not accessible to children and
third parties to prevent misuse of the machine.
NOTICE
► Do not store the device in direct sunlight.
► Only store the device at an ambient temperature between 0°C and +40°C and
make sure that the environment is free of moisture.
► To transport the unit, pack the unit so that it is protected from impact. Ideally,
use the original packaging.
► Do not wrap the power cord around the unit. It may result in broken insulation
and cable damage.
28
Clippers head/Blades
Cause
1. Blade tension is too
high
2. Blade or head are
dry
1. Blade tension is too
low
2. Blades have rust on
them
3. Blades are dull or
poorly sharpened
1. Eccentric defective
2. Defective reduction
gearing
3. Clipper head
knocked out
INSTRUCTION MANUAL VOSS.FARMING EASYCUT
Solution
1. Adjust the blade tension with
the tensioning nut. If this solves
the problem and the machine
stops cutting, the blades must be
sharpened.
2. Oil the blades/clipper head.
1. Increase the blade tension with
the tensioning nut.
2. Have the blades sharpened in
a specialist shop. If there is too
much rust, replace the blades with
new ones.
3. Have the blades sharpened in a
specialist shop.
Contact the manufacturer.
85285 | 11 | 2020 | V2