Monitor Installation - Beeper RW037-P Instalación Y Uso

5. MONITOR INSTALLATION

Thanks to its rotating bracket and sticker, RW075LDV monitor can be placed anywhere in your
vehicle. The ideal position of your monitor is on the top of car roof near rearview mirror. If this
position is not possible or not appropriate, you can set the monitor on the dashboard so visible
during reversing. Make sure that the monitor is not too visible from outside the vehicle so as not
to attract thieves.
The screen is fixed by an adhesive on a backing high strength double-sided. We advise you to
clean and degrease the surface before bonding.
We recommend the use of a primary (our ref: RX-PR01 not supplied in this kit) allows maximum adhesion before bonding double-sided.
The primary must be applied on both parts receiving the sticker : monitor bracket + dashboard or rooftop part where the bracket will be stuck.
The rotating bracket allows you to use your screen in all directions, just rotate the image using the bottom button on the right side of the screen.
The wiring must be concealed in the amounts of windshield under the dashboard, under the trim and must not be apparent. There must not interfere
with the driver operation, put it away from heating elements.
24
95 mm
89 mm
88 mm
60 mm
24 mm
76 mm