Setup Menu - Briteq POWERPIXEL4-RGB Manual De Instrucciones

ENGLISH
 Always use a certified safety cable that can hold 12times the weight of the device
when installing the unit. This secondary safety attachment should be installed in a way
that no part of the installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not
be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical
installations are approved by an expert before using them for the first time. The installations should be
inspected every year by a skilled person to be sure that safety is still optimal.

SETUP MENU

With the setup menu you can fully configure the projector. All settings are preserved when the unit is
disconnected from the mains.
Browsing the setup menu:
General instructions for setup.
 Press the MODE button to browse the
different functions of the setup menu
until the required function is shown on
the display.
 Press the ENTER button to access
the function and
parameters.
 The cursor of the value to change
starts blinking. Use DOWN and UP
button to change the value.
 Press
the ENTER
confirm and select the next parameter
to adjust.
DMX MODE + ADDRESS
Used to set the DMX channel mode
and start address.
 Press the MODE button until "DMX
MODE" is shown on the display.
 Press the ENTER button: the channel mode (number of channels used) can be set.
 Use DOWN and UP buttons to change the value to the desired channel mode:
 POWERPIXEL4-RGB modes:
 03CH: all 4 projectors together RGB
 04CH: all 4 projectors together RGB + master dim/audio/strobe channel
 05CH: all 4 projectors together RGB + master dim + audio/strobe channel
 06CH: 2 groups of 2 projectors RGB + RGB
 12CH: all projectors individually RGB
 15CH: all projectors individually RGB + 3 channels for special functions.
 16CH: all projectors individually RGB + master dim
 POWERPIXEL8-RGB modes:
 03CH: all 4 projectors together RGB
 04CH: all 4 projectors together RGB + master dim/audio/strobe channel
 05CH: all 4 projectors together RGB + master dim + audio/strobe channel
 06CH: 2 groups of 4 projectors RGB + RGB
 12CH: 4 groups of 2 projectors RGB + RGB + RGB + RGB
 24CH: all projectors individually RGB
 27CH: all projectors individually RGB + 3 channels for special functions.
 32CH: all projectors individually RGB + master dim
 Press the ENTER button: the start address can be set, the display shows start + end address: "xxx-yyy".
 Use DOWN and UP buttons to adjust the start address (xxx).
Note: Depending on the channel mode, the end address (yyy) of the projector changes automatically. This
makes it easy for you to set the start address of the next projector in the DMX-line.
BRITEQ
®
change its
button again
4/64
OPERATION MANUAL
POWERPIXEL4+8-RGB