DeWalt DWS7085 Manual De Instrucciones página 14

EN GLI SH
Markings on Tool
Read instruction manual.
For indoor use.
Short-circuit-proof safety isolating
transformer.
DATE CODE POSITION
Date Code, which also includes the year of
manufacture, is printed on the inside of the
worklight. On the power supply, the date code is
located on the bottom.
Example:
2008 XX XX
Year of Manufacture
Installation of Miter Saw LED
Worklight System
WARNING: Read all instructions for the
Installation of Worklight Power Supply
and the Installation of Worklight before
proceeding with the Installation of the
Miter Saw Worklight System.
INSTALLATION OF THE WORKLIGHT POWER SUPPLY (WPS)
(FIG. 1–4)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: To reduce the risk of
serious personal injury, DO NOT
OPERATE SAW WITHOUT THE
COVER OR POWER SUPPLY IN
PLACE.
1. Remove the two screws from the miter saw
handle with the T20 wrench provided. Save the
screws to install the Worklight Power Supply
(WPS) in Step 4. Retain the handle cover for
future use if WPS is removed.
2. Attach the connections to the WPS (fig. 2).
3. Arrange the wire connection such that the wide
portion of the connector is placed against the
bottom of the miter saw handle and fit the WPS
to the handle (fig. 3).
4. Attach the WPS with the two screws removed
in Step 1 (fig. 4).
12
INSTALLATION OF THE WORKLIGHT (FIG. 5–8)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: To reduce the risk of
serious personal injury, DO NOT
OPERATE SAW WITHOUT THE
COVER OR WORKLIGHT IN PLACE.
WARNING: To reduce the risk of
serious personal injury, DO NOT
touch the sharp points on the blade
with fingers or hands when guard is
open.
1. Remove the four screws (a) with the the T20
wrench provided (fig. 5). Save the screws to
install the worklight in Step 4. Retain the cover
for future use if worklight is removed.
NOTE: Manually open the guard (b) if needed to
access and remove the lower two screws.
2. Attach the connection from lead wire to the
worklight (fig. 6).
3. Tuck the wire connection into the area in the
worklight as shown. Attach the worklight to
the saw (fig. 7).
4. Attach the worklight with the four screws
removed in Step 1. Tighten screws securely.
(fig. 8).
WARNING: Do not operate the miter
saw if any of the screws are missing,
stripped out or not seated.
5. Manually open and close the guard to ensure
no binding occurs. With the guard closed, move
the saw arm through a full stroke to also ensure
no guard binding occurs.
WARNING: To reduce the risk of
serious personal injury, do not
operate the saw if guard binding
occurs.
Use of Miter Saw Worklight System
(fi g. 9, 10)
WARNING: Read all instructions for the
Installation of Worklight Power Supply
and the Installation of Worklight before
using the Miter Saw Worklight System.