Spare Parts; Switching On And Off - Bosch DAF220 Miterfinder Manual Original

daf220_bu_2609140572_003.fm Seite 9 Montag, 8. September 2008 2:22 14

Spare Parts

Battery compartment
cover . . . . . . . . . . . . 1 609 203 928
End cap . . . . . . . . . . 1 609 203 770
Joint cover. . . . . . . . 1 609 203 927
Preparation
Insert the batteries before putting
into operation for the first time.
Slide the battery compartment
cover 4 in the direction of the rect-
angle point and open. While insert-
ing the batteries, make sure that
they are properly oriented
(see Figure B).
The tool automatically switches on
after the insertion of the batteries.
All display segments appear for
about 5 seconds while the unit per-
forms a self check and calibration.
Once it is completed, the tool dis-
plays the "current angle"; that is,
the present angle between the legs.
When the battery indicator
stays on, it indicates that the bat-
teries are running low and that
measurements can be made only
for about another 1–2 hours. If the
battery indicator starts to blink,
power is so low that measurements
are no longer possible, and the bat-
teries must be replaced.

Switching On and Off

– ON: Press button 11. All seg-
ments of the angle display ap-
pear briefly.
– OFF: When the tool is in the nor-
mal measuring mode, press but-
ton 11 for less than 1 second.
After 3 minutes without button
actuation or angle change, the tool
switches off automatically to maxi-
mize battery life.
Bosch Power Tools 2 609 140 572 | (8.9.08)
| 9