Battery Installation; Installation Of Battery; Removal Of Battery - RIDGID WD03180 Manual Del Usuario

Battery Installation

!
WARNING: Turn unit OFF before
removing/installing the battery.
NOTE: Lithium Ion Battery and Charger
sold separately.

Installation of Battery

NOTE: Use ONLY RIDGID brand 18 volt
batteries.
WD03180 will operate with the following
types of batteries: 18V Battery Numbers
R84008, R840083, R840084, R840085,
R840086 and R840087.
1. While holding the Wet/Dry Vac's
handle with one hand, pull open the
battery compartment cover.
2. Slide the fully charged battery into the
battery receptacle until you hear an
audible click. Do not push the release
buttons on the battery at this time.

Removal of Battery

1. Press both release buttons, located on
each side of the battery, at the same
time and slide battery out of the
battery receptacle.
2. Plug charger into a wall receptacle
and place battery into the charger to
recharge the battery.
! WARNING: To reduce the risk of
electric shock, do not handle
battery with wet hands or place wet
battery into charger.
10