Maintenance And Cleaning - Ega Master 67194 Manual De Instrucciones

Set the direction of rotation of the drill to the anticlockwise direction. Insert the screw-bit into the slot
in the head of the screw. Hold the screw-bit perpendicular to the head of the screw, otherwise the screw
or the screw head may be damaged. Press the screw bit against the screw with a constant pressure
while removing the screw.
Attention! Always remove the battery before carrying out any work on the machine.
To clean, always use a dry or moist, but not wet, towel. Many cleaning agents contain chemical
substances which may cause damage to the plastic parts of the machine. Therefore do not use any
strong or inflammable cleaners such as petrol, paint thinner, turpentine or similar cleaning agents.
Always keep air ventilation holes free of dust deposits to prevent overheating.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine being
incorrectly used or, applied for a purpose for which it was not intended.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must be
collected and arranged separately. If you have to throw them out, please, do not use the usual rubbish.
Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
SCREW REMOVAL

MAINTENANCE AND CLEANING

NOTES
GUARANTEE
13