Astralpool OPTIMA PLUS Manual De Instalación página 8

Paragraph 3 – Manual Dosage
Programming
P R O G
C o n f i g u r a t i o n
P u m p F u n t i o n s
-
+
P u m p
F u n c t i o n s
Display during Operation
Operating mode
•
Man = Manual
Alarms and statuses
•
Liv = Level alarm
•
Fls = Flow alarm
Paragraph 4 – RS485 Settings
Programming
PROG
Pump Functions -
-
RS485 Settings
RS-485 Off
-
EM00136408
The pump operates in constant mode. The flow can only be manually
regulated by pressing the
the flow, or the
FLOW sensor
status
MAN F F F
Lev Stop P100%
Pump status
•
Empty = pump in start
•
Stop = pump stationary
•
Paus = pump in pause
RS485 Settings
+
RS-485 On
-
-
RS485 Settings
BaudRate - 9600
-
RS485 Settings
-
Parity Even
-
RS485 Settings
-
Address 1
-
RS485 Watchdog
Timeout - Off
-
WDG Config.
Hardware Reset
-
Current dosage value
(depends on the selected unit
of measurement)
•
Percentage, Frequency,
l/h, Gph, ml/m
This makes it possible to activate (deactivate) the ModBus
RS485 communication (On by Default).
If Active in the menu will show following items:
-BaudRate: it's possible to set the BaudRate as 2400,
4800, 9600, 19200 or 38400 (9600 by Default).
-Parity: it's possible to set the Parity as Even, Odd or No
(disabled).
-Address: it's possible to set the address communication
of device from 1 to 247 (1 by Default).
+
-Timeout: It's possible to set the Watchdog timeout, if Off
is disabled otherwise it's possible to set a time from 1 to
+
65535 seconds (Off by Default).
-Hardware Reset: it's possible to set the Watchdog
+
communication as Hardware Reset, Com. Reset, Stop
Dosage and WDG Alarm (WDG Alarm by Default) .
+
Changes can be made by pressing the
+
using the
to confirm and return to the main menu
rev. 1.0
Operation
keys at the same time to increase
keys to decrease it.
Display during Setting (MODE key)
Operating mode
•
Displays the corresponding frequency value
F320s/m
Current dosage value
•
The maximum flow can be modified by
pressing the + or – keys at the same time
Operation
keys to set the new value. Press
P100%
key, then
6