Installing Batteries; Basic Connections - Vox StompLab IIG Manual De Usuario

2. OUTPUT/PHONES jack
Connect this jack to your guitar amp, mixer, recorder or
headphones.
3. POWER button
To turn the power on or off, press and hold down this button
for 1 second.
4. DC 9V jack
You can connect an optional AC adapter to this jack.

Installing batteries

Do not mix new batteries and used batteries or different types
of batteries together.
1. Remove the 4 screws from the rubber feet that secure the
bottom cover.
2. Insert four AA-size batteries, being sure to observe the correct
polarity ("+" and "-" markings), and close the bottom cover.
If the battery level becomes low, noise may be generated.
6
Setup

Basic connections

Be sure to connect all cables with the power turned off. If you
fail to use caution when connecting cables, you could damage
your guitar amp or speaker system, or cause other malfunctions.
1. Use a cable to connect the StompLab's OUTPUT/PHONES jack
to your guitar amp,mixer or recorder.
When connecting cables or turning on the power, make sure
to lower the volume of your amp or mixer so that you don't
hear noise
If you're using headphones, plug them into the OUTPUT/
PHONES jack.
If you're using the optional AC adapter, connect it to the
rear panel DC9V power supply jack, and then plug the
adapter into an AC outlet to turn the power on.
2. Connect your guitar to the rear panel INPUT jack.
3. Press and hold the power button and release the button when
the program/value display lights up.
When the StompLab starts, the program/value display will
indicate the program number.
4. Raise the volume of your amp or mixer to the appropriate volume.