Changing The Engine Oil And Filters Extraction - Beta RR 390 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

3
ChaNGiNG ThE ENGiNE Oil
aNd filTERS ExTRaCTiON
Before performing this operation, remove
the lower bumper a, after underscrewing
the three screws B as shown in the figure.
Whenever the oil is changed, is necessary
to change the paper filter and to clean the
wire netting filter.
The oil must be changed when the engine
B
a
is at operating temperature.
WARNING
When at operating temperature, the en-
gine and the oil it contains are very hot.
Take special care to avoid burns.
Park the motorcycle on level ground,
remove screw C and let the oil drain in
a container.
Thoroughly clean the screw and wire
netting filter. After the oil has drained com-
B
pletely, clean the sealing surface, replace
screw C with the seal ring and wire netting
filter and tighten at 20 Nm.
In order to let the oil drain it's necessary to
unscrew just the screw C.
C
GB
37

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Rr 430Rr 480

Tabla de contenido