Cobra MicroTalk PR4000WX Manual Del Propietário página 12

Using Your Radio
Operation
"Roger Beep" Confirmation Tone
Your listener will hear an audible tone when you
release the Talk button. This alerts the other party
that you are finished talking and it is OK for them
to speak. This feature can be turned On or Off.
To Turn "Roger Beep" On or Off:
Mode Button
When turning On your microTALK
for the first time, "Roger Beep" will be On.
1. Press the Mode button until the Roger
Beep icon flashes on the LCD. The current
Roger Beep On
On or Off setting is displayed.
2. Press the Channel Up or Channel Down
button to select "Roger Beep" On or Off.
3. a. Press the Mode button to enter the new
Channel Button
setting and proceed to other functions.
b. Press the Lock button to enter the new
setting and return to Standby Mode.
The setting you select will be saved when you
turn your radio Off and On again. When the
"Roger Beep" is On, the "Roger Beep" icon
will be displayed.
Keystroke Tones
Mode Button
With Keystroke Tones turned On, your radio
will sound beeps each time you press a button
or change a setting.
To Change Keystroke Tones:
Keystroke Tones On
1. Press the Mode button until the Keystroke
Tones icon flashes on the LCD. The current
On or Off setting is displayed.
2. Press the Channel Up or Channel Down
Channel Button
button to turn Keystroke Tones On or Off.
3. a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press the Lock button to enter the new
setting and return to Standby Mode.
20 English
Introduction
Compass Icon
•
® radio
Compass Button
CALIbr Compass
Parallel To Ground
•
Success
Fail
Operation Customer Assistance
8-Point Digital Compass
Your microTALK ® radio features an 8-point
digital compass.
Because the surrounding terrain
can affect compass accuracy, it is
recommended that you calibrate
the compass before each use. It is
important to keep the radio parallel
to the ground at all times while
calibrating and using the compass.
To Calibrate the Compass:
1. Press and hold the Compass button for two
(2) seconds. The Compass icon and "CALIbr"
will appear in the display.
2. Hold the radio in front of you, parallel to the
ground, and turn around in a circle at least
two (2) times (or you may place the radio
on the palm of one of your hands, parallel
to the ground, and turn it in a circle at least
two (2) times with your other hand).
3. Press the Compass button again.
4. a. If compass calibration was successful,
"SUCCES" will appear in the display for
one (1) second, then the radio will
automatically return to Compass Mode.
b. If "FAIL" appears in the LCD, repeat steps
1 through 3. (If you receive repeated "FAIL"
messages, change locations and repeat
steps 1 through 3.)
Nothing comes close to a Cobra
Warranty
•
™ 21