METAWOOD MTTM2000-355 Traducción De Las Instrucciones Originales página 18

19 - Remain vigilant.
- Watch what you are doing, demonstrate common
sense and do not use the tool when you are tired.
20 - Check damaged parts.
- Before using the tool for other purposes, examine
it carefully to determine whether it will operate
correctly and accomplish its planned function.
- Check the alignment or locking of the moving
parts, and the absence of any broken parts or any
fixing and other conditions that are likely to affect
the operation of the tool.
- A protective guard or other damaged part should
be repaired or replaced by an approved
maintenance centre, unless stated otherwise in this
instruction manual.
- Have defective switches replaced by an approved
maintenance centre.
- Do not use the tool if the switch does not permit
change from the on state to the off state.
21 – Warning.
- The use of any accessory or any fixing other than
that or those recommended in this instruction
manual can present a risk of injury to persons.
22 - Have the tool repaired by a qualified person.
- This electric tool satisfies the corresponding safety
rules. Repairs should only be made by qualified
persons using original spare parts. Not doing this
can expose the user to significant danger.
SYMBOLS
In this manual and/or on the machine the following
symbols are used:
Read manual before use.
Always wear a dust mask.
For your safety, remove the
chips and other small pieces on
the table before starting work.
In accordance with essential
applicable safety standards
of European directives
Warning / Danger!
Wear ear protection.
Wear eye protection.
ADDITIONAL SAFETY INSTRUCTIONS FOR CUT-
OFF MACHINES
• Always wear regular working gloves while
operating this tool.
• Keep hands away from the cutting disc. Never
cut workpieces that require manual action closer
than 15 cm from the rotating cutting disc.
• Do not cut workpieces less than 1.2 mm in
thickness when using the cutting disc supplied
with this tool.
• Do not operate this tool without guards in place.
• Do not perform any operation freehand. Use the
material clamp to clamp the workpiece securely.
• Never reach in the back of the cutting disc.
• Always position the tool on a fl at, stable
surface that is well maintained and free of loose
materials, e.g. chips and cut-offs.
• Before using, inspect the cutting disc for cracks
or fl aws. Discard the cutting disc if a crack or
fl aw is evident.
• Make sure the cutting disc is not contacting the
workpiece before the tool is switched on.
• In operation, avoid bouncing the cutting disc or
giving it rough treatment. If this occurs, stop the
tool and inspect the cutting disc.
• Do not operate the tool while standing in line with
the cutting disc. Keep other persons away from
the work area.
• Be aware of cutting chips and the material being
18
speed
Disc Diameter
Cutting width
Depth of cut
Cut angle