Wall Mounting - CMP DEL Ozone 25 Instrucciones De Instalación Y Manual Del Producto

Section 2 Installation
2B. Wall Mounting
1. Open the Enclosure Door and locate the three mounting holes on
the back wall of the Enclosure. There will be two holes located near
the top on the left and right and one located in the center near the
bottom. Refer to Figure 1 for clarification.
2. Install screws (or other hardware appropriate for the mounting
surface) through the two mounting holes near the top of the
enclosure. Install the last screw through the mounting hole near
the bottom of the enclosure. Mounting hardware must be driven
until the head fully contacts the enclosure wall. Mounting hardware
head must not be smaller than 0.25 inches (6.3 mm) in diameter
and the threads of the hardware must be smaller than 0.25 inches
(6.3 mm) in diameter.
5.77
2.68
19.60
Ozone 100
Figure 1: Mounting Hole Dimensions
3X .25
3X .25
Ozone 25 & Ozone 50
2
5.77
2.68
12.40