Controller Installation - Toro Lawn Master II Guía De Instalación Y Programación

Ocultar thumbs Ver también para Lawn Master II:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Controller Installation

For safe, reliable operation, select an installation site which is:
• Weather protected.
• Within 4 ft. (1.2 m) from a grounded 110 VAC, 60 Hz outlet which is not controlled by
a light switch or utilized by a high current load appliance, such as a refrigerator,
air conditioner or garage door opener.
• Accessible to the sprinkler control valve wiring and optional accessory wiring.
Step 1 – Use the Screw Location Template on the back page to mark the screw locations.
Use a level to align the two screws horizontally. Install two screws, 5 inches
(12.7 cm) apart, into the wall at eye level. Leave the screw extended approximately
1/4 inch (6 mm) from the wall to accommodate the controller case.
If installing into drywall or masonry, install proper screw anchors.
Step 2 – Hang the cabinet using the back panel's keyhole slot. Make sure the cabinet slides
down securely onto the screws.
Step 3 – (Optional) Remove the controller's access panel and install a center mounting screw.
Tighten securely.
5'' (12.7cm)

lawn
master
SENSOR
ON
OFF
PRG
RS1 RS2 AC1 AC2 COM MV
S1
S2
S3
S4
S5
S6
(Optional)
Questions?
Call the Toro Helpline
(800) 367-8676
www.toro.com

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

5380553806

Tabla de contenido