Master Valve & Station Connection; Important - Toro Lawn Master II Guía De Instalación Y Programación

Master Valve and Station Connection
Using 18 -gauge (maximum 14 -gauge wire can be used), multi -strand, direct burial
irrigation valve connection cable is recommended. Select a cable that provides at least one
wire for each valve and one extra wire for the common connection.

IMPORTANT!

connectors on all splices.
Step 1 – To provide a valve common connection, splice one cable wire (generally the white
wire) and connect it to one solenoid lead from each of the valves.
Step 2 – Connect a separate wire to the remaining solenoid lead from each valve.
For reference, note the wire color code being used for each valve connection
and the associated watering station.
Step 3 – Remove the controller's lower
panel cover to access the master valve
and station terminals.
Step 4 – Route the wire cable into the controller
through the opening at the base of the
unit.
Step 5 – Secure the designated valve common
wire to the "
Step 6 – Secure the Master Valve to the "
terminal and the stations to their
corresponding terminals (
Step 7 – Reinstall the lower panel cover.
To prevent corrosion and possible short circuit, use waterproof wire
COM
" terminal.
S1, S2, S3, ...
MV
"
).
lawn
master
SENSOR
ON
OFF
PRG
RS1 RS2 AC1 AC2 COM MV S1 S2 S3 S4 S5 S6
COM
S3
S2
S1
MV
COM
Questions?
Call the Toro Helpline
(800) 367-8676
www.toro.com
9-Volt
Battery