Selecting The Method Of Connecting To Your Computer; Usb Connection; Configuring Wi-Fi Settings On The Printer Touch Screen - Canon imagePROGRAF TA-30 Guía De Configuración

6

Selecting the Method of Connecting to Your Computer

When something like the following is displayed on the touch screen, select the connection method.
Important
●
Initial filling of the ink (approx. 11-12 minutes) and cleaning are performed during this operation, and the remaining ink level is reduced by this operation.
●
Since the included starter ink tanks are for initial installation, it is recommended that you purchase replacement ink tanks quickly. Note that 2 MBK ink tanks
are included with this product. A message asking you to install the second MBK ink tank may be displayed after the initial filling. If this happens, remove
the ink tank that you first installed and then install the second ink tank.
Wired LAN connection
1
Select Wired LAN connection.
Check the message about the
connection method and select Yes if
there are no problems.
● Initial filling of the ink starts. Do not
open the covers of the printer or
turn the power off while the ink is
charging.
A message prompting you to
●
connect the LAN cable appears.
2
Use the LAN cable to connect the
wired LAN connector on the side of
the printer to the hub port.
3
Select OK and proceed to "Installing
the Software on Your Computer" (p.
10).

Configuring Wi-Fi Settings on the Printer Touch Screen

1
Check that the following screen
appears and select OK.
Note
●
If any of Checking the nozzle, Preparing
the ink system, or Cleaning... is displayed,
the printer initial settings are not finished.
Wait until the above screen appears.
Connect the printer to the network using a LAN cable.
Connect the printer to the network wirelessly without using a LAN cable.
Connect the printer to a computer using a USB cable.
Select this such as when connecting using a fixed IP address. The connection settings and software installation
will need to be performed separately. Start the settings from the touch screen of the printer.
Wi-Fi connection
1
Select Wi-Fi connection. Check
the message about the connection
method and select Yes if there are
no problems.
● Initial filling of the ink starts. Do not
open the covers of the printer or
turn the power off while the ink is
charging.
A message prompting you to set up
●
Wi-Fi connection appears.
2
Select Yes and proceed to "Installing
the Software on Your Computer" (p.
10).
● To configure the settings from the
printer, select No and proceed
to "Configuring Wi-Fi Settings on
the Printer Touch Screen" (column
below).
2
Select the connection method.

USB connection

1
2
Only for Wi-Fi connection
3
4
9
Select USB connection. Check the
message about the connection
method and select Yes if there are
no problems.
● Do not connect the USB cable yet.
● Initial filling of the ink starts. Do not
open the covers of the printer or
turn the power off while the ink is
charging.
Select OK and proceed to "Installing
the Software on Your Computer" (p.
10).
Configure the settings by following
the instructions on the screen.
● When the home screen appears
and (network) appears, the Wi-Fi
settings are complete.
Proceed to "Installing the Software
on Your Computer" (p. 10).