Descargar Imprimir esta página

Astralpool 73158 Manual De Instalación Y Mantenimiento página 5

Skimmer filtrante

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 13
• Fit the mouth to the swimming pool by inserting it inside the
swimming pool tightening the 16 screws.
• First remove the flap, glue the mouth and skimmer body parts
to the areas indicated in the diagram with the adhesive provided.
The area must be clean and dry.
• If necessary, fix the skimmer base to the ground.
• Place the brackets as shown in the diagram. Do not handle the
skimmer for 24 hours. After 24 hours, check that the adhesive
has dried fully.
THE MANUFACTURER ACCEPTS NO LIABILITY FOR GLUING
CARRIED OUT BY THE INSTALLER OR THE CUSTOMER.
• Replace the flap removed previously.
• The skimmer has side connections for fitting, if necessary, a suc-
tion nozzle and ensuring a constant flow rate of water to the pump.
They can also be used to hang the skimmer on a wall.
Make the necessary connections to the suction nozzles, fo-
llowing the swimming pool regulations in force in your country. The
nozzles must be installed 2 meters apart and always glued in Ø50
mm tubes.
• Skimmer 73160 has 2 side connections, skimmer 73163 has 3
side connections. All the connections are covered but they are easy
to open thanks to the perforation.
• Continue the assembly by inserting the different parts: glue a flat
seal to the pool's inner wall; put the liner in place in the pool; glue
the other flat seal.
Put the flange in place and screw it in using the 18 DIN 7982
5.5x25mm (A) screws.
• Click the faceplate in place.
• The skimmer cover can be adjusted in height and pivoted, if ne-
cessary, to make it flush with the outside edge of the swimming pool.
• During operation ensure that the water level is high enough to
prevent air absorption. In the event the water level is too high, the
skimmer is fitted with a water intake to evacuate excess water.
POOL PANEL
LINER
Standards to be
followed:
EN-13451-3
EN-16713-2
Installation of
suction inlets or
wall support
*
Nozzles and pipes not included with the product
5
ABS adhesive
supplied
Pre-cut die
Ø50
Pump
connection
Ø63
Pre-cut die Ø50
Pool floor

Publicidad

loading

Este manual también es adecuado para:

7316173159731607316273163