Bftr138 Led Display; Bftr146 Led Display; Power Save Mode - Black and Decker BFTR138 Manual De Instrucciones

SET UP & USE

BFTR138 LED DISPLAY

I NM
II NT
III SL
1/2 H 2H
1 H 4 H
Page 10
POWER: Turn the FAN on by pressing the
'POWER' button; Turn the FAN off by pressing
the 'POWER' button again.
SPEED: You can adjust the fan speed to
the desired level: low, medium, or high by
pressing 'SPEED'. The corresponding LED
light I (Low), II (medium) and III (high)
will illuminate.
MODE: Pressing the' MODE' button will set
the FAN to NORMAL, NATURAL, or SLEEP
mode.
• The default mode is NORMAL and
provides a steady air flow.
• NATURAL mode cycles through low,
medium and high fan speeds for 5
seconds each.
• In SLEEP mode the fan will cycle to a
lower fan speed after 30 minutes of
operation when set at either a high or
medium fan speed.
The NM (Normal), NT (Natural) and SL (Sleep)
will illuminate to indicate the selection.
TIMER: The fan is equipped with a timer
that allows you to set its length of operation
from 1/2 hour to 7 1/2 hours. Continue to
press the TIMER button to scroll through
the different time selections of 1/2 hour, 1
hour, 2 hours, and 4 hours. The combination
of selections 1/2H, 1H, 2H and 4H will be
illuminated. The fan will automatically shut-off
after the selected duration.
OSC: Pressing the 'OSC' button will start
and stop the oscillation function.
SET UP & USE

BFTR146 LED DISPLAY

POWER: Turn the FAN on by pressing the
'POWER' button; Turn the FAN off by pressing
the 'POWER' button again.
TEMPERATURE: The LED display will
illuminate and show the room temperature.
The temperature display will change to
'TIMER' when the timer is set.
SPEED: You can adjust the fan speed to
the desired level: low, medium, or high by
pressing 'SPEED'. The selected fan speed will
be displayed on the LED display.
MODE: Pressing the' MODE' button will set
the FAN to NORMAL, NATURAL, or SLEEP
mode.
• The default mode is NORMAL and
provides a steady air flow.
• NATURAL mode cycles through low,
medium and high fan speeds for 5
seconds each.
• In SLEEP mode the fan will cycle to a
lower fan speed after 30 minutes of
operation when set at either a high or
medium fan speed.
The (Normal), (Natural) and
(Sleep) will illuminate to indicate the
selection.
TIMER: The fan is equipped with a timer
that allows you to set it's length of operation
from 1 hour to 12 hours. Continue to press
the TIMER button to add time in 1 hour
increments. The time selected will show on the
LED Display. The fan will automatically shut-
off after the selected duration.
OSC: Pressing the 'OSC' button will start
and stop the oscillation function.
POWER SAVE MODE: When the 'sleep' mode
or the 'timer' is on, the LED display will turn off
after 30 seconds. Press any key to turn on the
display again.
Page 11