General Warnings; Safety Precautions - Craftomat 9045879CFT Manual De Instrucciones

GENERAL WARNINGS

When using air-powered accessories, always wear safety clothes.
Keep the work area free and always maintain a stable position.
Do not allow inexpert persons to use tools without suitable supervision. Keep children and animals at a distance from the work
area; improper use of compressed air may cause serious injuries.
BLOWING GUN
TECHNICAL DATA Max. pressure: 8 bar
INSTRUCTIONS FOR USE Connect the air hose to the inlet fitting (1) on the gun. Direct the nozzle towards the area or object to be blown
and press the lever (2). The flow of air can be adjusted by regulating pressure on the lever (2).
INFLATION GUN

Safety precautions:

● Do not direct the stream of compressed air towards people, animals or your body.
● Do not exceed the value of maximum pressure rating of the inflating gun, printed on the back of its body.
● Never inflate the objects above the maximum allowable pressure (recommended by the manufacturer) as this may be dangerous
and cause damage and/or injuries.
● The gun is not suitable for inflating car tyres. For this operation, use of the homologated inflating gun that can be purchased
separately, is recommended.
TECHNICAL DATA Max. pressure: 10 bar
INSTRUCTIONS FOR USE Connect the air hose to the inlet fitting (1) on the gun. To inflate the tire and check pressure, insert the fitting
(2) in the valve of the tire holding down the lever (3) on this; following insertion, release the lever (3). With the gauge facing you, read
the pressure; for inflation, press the lever (4) fully for a few seconds and then release it; repeat the operation until you have obtained the
pressure required as shown by the needle on the dial of the gauge. For deflation, release the lever (4) and press the button (5) with your
thumb until all the air has been expelled. (figures 3 – 4).
When inflating footballs, rubber dinghies, certain bicycle tires and children's inflatable swimming-pools, you may have to use a suitable
adapter.
Select the suitable adapter and insert it in the inflation hose pressing tab (3) (fig. 2.1). Push the adapter in the inflation hose a shown in figure
2.1 and release tab (3). To fasten the adapter, turn it slightly in a clockwise direction.
Ball needle (Figure 5)
Range of applications: For inflating balls. The ball needle can be used to inflate a variety of different balls.
f TIP: To avoid damaging the valve, moisten the needle slightly before inserting it.
Valve adapter (Figure 6)
Range of applications: For Dunlop cycle tyre valves. This Dunlop valve adapter is designed for inflating cycle tyres.
Adapter 7 (Figure 7)
Range of applications: For all valves with an internal diameter of 8 mm or more. You can use this adapter to inflate airbeds, pools or boats.
f TIP: Insert the adapter 7 into the valve as shown in Figure 7, drawing 7.1.
Important! The valve cap must be opened a little by being pressed together slightly.
Adapter 8 (Figure 8)
Range of applications: For screw valves. This adapter can be used for all conventional boats, kayaks and other large items such as pools,
which are fitted with a screw valve.
Vent adapter (Figure 9)
Range of applications: For deflation valves. You can find a deflation valve combined with other valves (standard valve, screw valve, etc.)
on many large articles such as an inflatable mattress.
Conical universal adaptors (Figure 10-11)
Range of applications: For inflating airbeds and similar.
8
EN
1
2