Cooper Metalux UHB Instrucciones De Instalación página 3

Wire Guard Installation
1. Install plastic spacers on screws, then feed through
eyelet on wire guard and screw into the fixture.
(Figure 5.)
Figure 5.
2. Tighten all four screws. (Figure 6.)
Figure 6.
Reflector Installation
1.
UHB High Bay
Wire Guard
Plastic Spacer
Screw
Figure 7.
2.
Screwdriver
Figure 8.
COOPER LIGHTING SOLUTIONS
Installation Instructions – UHB
Install all four screws into the mounting holes, leaving a
3mm gap from the fixture. (Figure 7 .)
Align reflector keyhole slots with screw and rotate the
reflector clockwise until it stops. (Figure 8.)
IB507017EN
Screw
Reflector
Installation instructions
3