Operation And Handing; Filling The Water Tank; Remote Control Usage; Battery Installing - Caso AirVital Pro Manual De Instrucciones

13 Operation and Handing

This chapter provides you with important notices with regard to operating
the device. Observe the following notices to avoid dangers and damages:

13.1 Filling the water tank

Take the nozzle (1) and handle cap (2) (linked from).
Remove the tank (4) from the chassis.
Remove lid (8) and fill the water tank of tap water or filtered water is.
They seal the tank by screw the lid carefully.
Place the water on the housing.
Put on the nozzle (1) and handle cap (2) and plug the power cord.
► Do not add water directly to water sink, always add water into water
tank.
► Before using the humidifier for the first time, all parts should be cleaned
with tap water.
► Fill in any water that is hotter than 40 ° C, no flavor additives or
chemical additives.
► Make sure that the tank is sealed and no water escapes.
► The outlets for water vapor can be rotated 360 ° in different directions.
► If the water is used up, the display flashes "on water" and the unit
switches off automatically.
► Turn off the device using the switch on / off, disconnect the plug from
the outlet and fill for water.
Please let the unit cool down 60 min. Before you take of the water tank
and refill with water. Attention: The device is hot!

13.2 Remote control usage

13.2.1

Battery installing:

Please pull out the battery holder at the end of the remote control. Then
put the coin cell with marking upwards into the holder and push back the
holder into the remote control.
caso AirVital Pro
Note
1. Battery
2. Battery holder
37