Health And Safety; Intended Use; Installation, Configuration And Maintenance Instructions - Steiel EF110 pH Manual De Instalación, Programación Y Mantenimiento

ENGLISH

HEALTH AND SAFETY

The pump must be operated ONLY by authorized and trained technical personnel.
All instructions and prescriptions in the technical manual must be strictly followed.
Failure to follow these instructions can result in serious damages to the equipment and,
in extreme cases, to people.
Warnings
This manual is dedicated to the technical personnel responsible of the installation, management
and maintenance of the plants. The manufacturer assumes no responsibility for damages or
malfunctions occurring after intervention by non-authorized personnel, or not compliant with the
prescribed instructions.
All maintenance or repair must be performed with the system isolated both electrically and
hydraulically. Before performing any operation on the pump, unplug the pump and discharge
the liquid from the pump head and tubes. Never operate on working pump!
During maintenance and repair of parts that normally become in contact with chemicals, always
wear all prescribed personal protections (gloves, clothes, glasses, etc.).
Any intervention must be performed ONLY by qualified personnel and using original spare parts.
Dispose of waste material and consumables accordingly with local regulations.

Intended Use

The pump can only be used after correct and proper installation and start-up, accordingly with the
technical data and specifications listed in this instruction manual.
Observe the general restrictions on the viscosity ranges and chemical resistance of the materials in
contact with the dosed product.
Do not dose hydrochloric acid, because it could damage the Santoprene internal tube.
The pump must only be used for liquid dosing.
All other uses are prohibited and any possible modifications.
The pump is not suitable for dosing gaseous or solid media.
The pump is not suitable for dosing combustible substances without appropriate protective measures, it is
not designed for dosing explosive liquids and is not intended for use in hazardous area.
The pump is not intended for use outdoors without appropriate protective measures.
Safety
The pump can start to dose as soon as it is powered. It is recommended to install an
emergency switch in the power line or connect the pump to the emergency stop system of the
installation.
Risk of electric shock! If the pump housing is damaged, immediately unplug the pump and
power it again only after a proper repair by an authorized technician.
EF110_r1.0 – 10/2019 p. 13