Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
PARA INSTRUCCIONES DE INSTALACIÓN EN ESPAÑOL, VEA LA PÁGINA 3-4.
Type 315
Step 1
Clean pipe surface thoroughly, particularly in area where gasket will seat.
Step 2
Check gasket for proper positioning in saddle body.
Step 3
Lubricate pipe and face of gasket with a suitable lubricant.
Step 4
Mount saddle body (with gasket in place) on pipe.
Step 5
Install saddle strap(s), nuts and washer(s).
Step 6
Prior to tightening, position saddle as required to suit installation.
Step 7
Tighten nuts progressively and uniformly (40 ft. lbs. maximum recommended torque).
Do Not Over Torque! Over torquing will not increase sealing ability and may cause failure in the pipe or
saddle.
Caution: Bolt length A and B must be kept equal.
Step 8
Make connection to saddle boss. Suitable pipe thread sealant is recommended. Do not cross thread.
Note: Use of this product on plastic pipe is limited to:
1. 4.50 - 12.75 Steel O.D. PVC Pipe with a standard dimension ratio of 26 or less.
2. 4.80 - 21.60 Cast Iron O.D. C-900 PVC Pipe Class 150 rating or better (DR18).
Do not use on fiberglass reinforced plastic pipe, plastic irrigation pipe, or plastic pipe other than sizes and
types mentioned above. See other side for P.E. pipe installation instructions.
Water and Industrial
A
Questions: Call 1-800-643-9705 or visit www.smith-blair.com
Installation Instructions
Type 315 & 317
Service Saddles
B
TI-010
Type 317
1
Publicidad
Resumen de contenidos para Smith-Blair 315
- Página 1 2. 4.80 - 21.60 Cast Iron O.D. C-900 PVC Pipe Class 150 rating or better (DR18). Do not use on fiberglass reinforced plastic pipe, plastic irrigation pipe, or plastic pipe other than sizes and types mentioned above. See other side for P.E. pipe installation instructions. Questions: Call 1-800-643-9705 or visit www.smith-blair.com...
- Página 2 Because of P.E.’s thermal con- traction, Belleville spring washers are required on the straps. Smith-Blair belleville washers (P/N 150115-002) must be used on P.E. pipe installations. Use of any other type of spring washer may cause product failure. Step 1 Clean pipe surface thoroughly, particularly in area where gasket will seat.
- Página 3 Agua y Drenaje TI-010 INSTRUCCIONES PARA SU INSTALACIÓN Tipo 315 y 317 Silletas de Servicio Tipo 315 Tipo 317 Punto 1 Limpie la superficie de la tubería perfectamente, particularmente el área en donde se instalara el empaque. Punto 2 Compruebe que el empaque a colocar se encuentra de manera apropiada en la silleta.
- Página 4 Belleville en el montaje de las correas. Arandelas Smith-Blair Belleville (NO. DE PARTE 150115-000). Deberá ser usada en instalaciones de tubería de P. E. El uso de cualquier otro tipo de arandela de resorte podrá causar fallas en el pro- ducto.