Publicidad
Idiomas disponibles
Idiomas disponibles
PARA INSTRUCCIONES DE INSTALACIÓN EN ESPAÑOL, VEA LA PÁGINA 3-4.
Smith-Blair belleville washers (P/N 150115-002) must be used on P.E. pipe installations. Use of any
other type of spring washer may cause product failure.
Step 1
Clean pipe surface thoroughly, particularly in area where gasket will seat.
Step 2
Check gasket for proper positioning in saddle body.
Step 3
Lubricate pipe and face of gasket with a suitable lubricant.
Step 4
Mount saddle body (with gasket in place) on pipe.
Step 5
Install saddle strap(s), nuts and washer(s). Place Belleville washers under nuts as shown. Prior to tighten-
ing, position saddle as required to suit installation.
Step 6
Tighten nuts progressively and uniformly (40 ft. lbs. maximum recommended torque).
Do Not Over Torque! Over torquing will not increase sealing ability and may cause failure in the pipe or
saddle.
Caution: Bolt length A and B must be kept equal.
Step 7
Make connection to saddle boss. Suitable pipe thread sealant is recommended. Do not cross thread.
Note: Use of this product on Polyethylene Pipe is limited to 4" - 16" Nominal P.E. Pipe with a standard
dimension ratio (DR) of 17 or less.
2
Water and Industrial
Installation Instructions
A
Questions: Call 1-800-643-9705 or visit www.smith-blair.com
on Polyethylene Pipe
Type 315 & 317
Service Saddles
B
Because of P.E.'s thermal con-
traction, Belleville spring washers
are required on the straps.
TI-010
Publicidad
