Re-Establishing Factory Settings And Control Reset; Error Messages - Lamborghini Caloreclima LAMBY-IN 20 MCS W TOP Manual Para La Instalación Y El Mantenimiento

RE-ESTABLISHING FACTORY SETTINGS AND CONTROL RESET

You may wish to re-establish the settings made at the factory: to do so press the
the message "Fab" will appear on the display.
Going through this procedure resets the following parameters:
- standard temperature
- comfort temperature:
- low temperature:
- standard timer programme
Pressing key R cancels all user-set data.
In this case it will be necessary to reset all the parameters starting from section 1.

ERROR MESSAGES

In the event of a boiler malfunction the control unit governs the warning signals and is used to reset normal
operation.
Warnings take the form of a code letter and a number (E XX) followed by the
displayed constantly where the anomaly can be reset and flashes when it cannot.
To reset a resettable anomaly and restore normal boiler operation press key A.
MESSAGE DISPLAYS
Code
Code
Code
Code
Code
20°C
20°C
17°C
E02 THERMOSTAT LIMIT (IF ANY)
E04 NO WATER
E05 HEATING SENSOR
E06 DOMESTIC HOT WATER SENSOR
E14 IGNITION FAULT
56
key for 10 seconds and
symbol. This symbol is