Descargar Imprimir esta página

Operating The Plasma Display; Basic Operations - FUNAI F42PDME Manual Del Usuario

Ocultar thumbs Ver también para F42PDME:

Publicidad

Idiomas disponibles

Idiomas disponibles

O
PERATING THE PLASMA DISPLAY

BASIC OPERATIONS

POWER
INPUT SELECT
The following is a simple explanation of the pro-
cedure for turning the power of the display ON or
in STANDBY and the procedure for selecting the
input signal.
The procedure described here is for the remote
control, however the POWER, INPUT SELECT
and VOLUME buttons on the plasma display can
also be used in the same way.
1
Press the POWER button.
Confirm that the STANDBY indicator is lit
before pressing the POWER button.
The power turns ON and the POWER indica-
tor on the main unit turns green. The STAND-
BY indicator on the main unit disappears.
NOTE:
• It takes approximately 8 seconds for the screen to
display after turning the power ON, but this is not
a malfunction.
2
Select the input signal by pressing the INPUT
SELECT button.
Each time you switch the input, the name of
the selected input terminal is displayed on the
screen for approximately 4 seconds.
NOTE:
• "No signal" is displayed on the screen if there is
no input from the selected terminal and there is
no message currently displayed on the screen for
volume adjustment or the setup menu, etc.
• If there is no video signal and there has been no
operation from the remote control or the buttons
on the main unit for more than 15 minutes, the
auto shut-off function activates and the display
switches to standby mode.
8
POWER
VOL
MUTE
SCREEN MODE
STILL
INPUT SELECT
DISPLAY
3
Adjust the volume and screen size according
to your requirements.
Perform adjustments to the volume (VOL K / L
button), screen aspect ratio (SCREEN MODE
button) and picture settings (MENU button).
NOTE:
• When you adjust the volume with the VOL K / L
button, a message such as the following is dis-
played on the screen. This message disappears
approximately 4 seconds after performing adjust-
ments.
• If you turn the audio mute on, a message slowly
flashes on the screen. At this time, if you press
another button, this flashing stops.
• To turn the audio mute off, either press the MUTE
button again or press the VOL K / L button.
• If you press either the PREVIOUS, K , L , B or {
button in a mode apart from the image adjustment
mode. A message such as the following is dis-
played.
4
Press the POWER button to turn the power
STANDBY.
The POWER indicator on the main unit turns
blue and the STANDBY indicator lights up.
NOTE:
• You cannot turn the power ON for approximately
3 seconds after the power enters the standby
mode. Do not turn the power to STANDBY and
then ON again in a short time interval.
• Even if the power is turned to STANDBY, the
main unit is in the standby mode. In order to shut
the main power of the display OFF, it is neces-
sary to remove the AC cord from the power out-
let.

Publicidad

loading

Productos relacionados para FUNAI F42PDME