Electrical Connection; Final Setup Operations - Whirlpool AGB 641/WP Manual De Instalación De Uso

Attention: in order to reach best performance and output rates all appliances must be
supplied with hot water 50 °C. If the machine is supplied with cold water, the production
capacity of the appliance is reduced in relation to the temperature itself.
Drain: all appliances are equipped with a pipe for connection to a drain trap in the floor.
Attention: check that there are no bends or constrictions along the entire lengths of the
filling and discharge pipes.
4.2

ELECTRICAL CONNECTION

The appliance is to be connected to a wall master switch of suitable power, provided with a
thermal release and the relevant switch unit. Three-phase models must be provided with a
power cable of suitable ength, H07RN-F type.
Attention: the grounding system is to be connected in full compliance with the current
regulations. Moreover, the appliance is to be set within an equipotential system by
connecting the screw located on the base and marked by the relevant sign. The
Manufacturer will not be liable for any direct or indirect damage arising from non-
compliance with the said regulations.
Before wiring the appliance assure that:
- the operating voltage rate corresponds to the rate shown on the appliance rating plate;
- wiring is carried out in accordance with wiring diagram.
5

FINAL SETUP OPERATIONS

- Turn water supply tap on and switch the wall master switch on.
- Make sure that there are no foreign bodies inside the dishwasher.
- Check that all the covering panels are fitted.
- Check that the overflow pipe is correctly positioned and secured.
- Make sure that the filter and the ring nut are firmly and correctly set in place.
- Make sure that the door is closed.
- Move the main switch 1 to the 1 position.
The power pilot light 2 will come on and at the same time the boiler and the tank will start
to fill and the heating resistances will come on.
- When the machine has reached a temperature of 50 °C in the tank and 85 °C in the boiler
(light 11 off), add non-foaming liquid detergent to the tank: about 50 cl. for the first load and
then about 25 cl. every 4/5 washes. In any case, follow the instructions for the dosage
recommendations provided by the manufacturer of the products.
ENGLISH 22