Statement Of Warranty - Mi-T-M Corporation THE WORK PRO WP-SERIE Operación Manual

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

The manufacturer warrants all parts, (except those referred to below), of your new pressure washer to be

free from defects in materials and workmanship during the following periods:

For One (1) Year from the date of original purchase:

High Pressure Pump

GFCI

For Ninety (90) days from the date of original purchase:

Trigger Gun/Wand

Unloader Valve

Strainer/Filters

Defective parts not subject to normal wear and tear will be repaired or replaced at our option during the

warranty period. In any event, reimbursement is limited to the purchase price paid.

1. The Engine is covered under separate warranty by its respective manufacturer and is subject to the terms

set forth therein.

2. Normal wear parts:

Pump Packings

Pump Valves

O-rings

3. This warranty does not cover parts damaged due to normal wear, misapplication, misuse, operation at

other than recommended speeds, pressures or temperature. Parts damaged or worn because of the use

of caustic liquids or by operation in abrasive or corrosive environments or under conditions causing pump

cavitation are not warranted. Failure to follow recommended operating and maintenance procedures

also voids warranty.

4. The use of other than Genuine Work Pro® Repair Parts will void warranty.

5. Warranty will be void if used in any application other than consumer/homeowner. Parts returned, prepaid

to our factory or to an Authorized Service Center will be inspected and replaced free of charge if found

to be defective and subject to warranty. There are no warranties which extend beyond the description

of the face hereof. Under no circumstances shall the manufacturer bear any responsibility for loss of use

of the unit, loss of time or rental, inconvenience, commercial loss or consequential damages.

WP-Cold Water Direct Driven Operator's Manual