Installation And Wiring - LEGRAND Wattstopper TDA-603 Instrucciones De Instalación

Tabla de contenido

Idiomas disponibles

3. For 3-way/multi-way installations, the Touch Remote (TDR) must be used in conjunction with the TDA-603. The TDA-603 is not

compatible with standard 3-way/4-way switches.

4. For multi-way installations, do not exceed 200 ft. of traveler wire between all the devices.

5. It is normal for the dimmer to feel warm to the touch during operation.

6. Protect the dimmer from dust and dirt when painting and spackling.

Derating

No derating is required for up to 4 devices ganged together. When 5 or more devices are ganged together it is necessary to derate all

devices to 500W, regardless of the type of load that is being controlled.

For ease of installation, manufacturer recommends use of a deep wall box.

1. Prepare the switch box

After the power is turned OFF at the circuit breaker box, remove the

the old switch out from the wall box.

2. Identify the type of circuit

You may connect the TDA-603 to a single pole or multi-way circuit. If you are unable to clearly identify some or all of the wires

mentioned in this manual, you should consult with a qualified electrician. In a 3-way circuit (Fig.3) two traveler wires connect to

both switches. Another wire provides power from the circuit box to one of the switches. A wire connects from one switch to the

load. A ground wire may also be connected to a ground terminal on the old switches

Caution – For your safety: Connecting a proper ground wire to the dimmer provides protection against electrical shock in the event of

certain fault conditions. If a proper ground is not available, consult with a qualified electrician before continuing installation.

HOT (power from

circuit box)

NEUTRAL

LOAD

Ground

(power

to lamp)

Fig 2: Typical Single Pole

Switch Wiring

3. Prepare the Wires.

Tag the wires currently connected to the existing switch so that they can be identified later. Disconnect the wires. Make sure the

insulation is stripped off of the wires to expose their copper cores to the length indicated by the "Strip Gage" in Fig. 4. (approx. ½ inch)

4. Wire the dimmer.

a. Single Pole Circuit: Wiring one TDA-603 (Fig. 5)

• Connect the green or non-insulated (copper) GROUND wire from the

circuit to the green wire on the dimmer.

• Connect the power wire from the circuit (HOT) to the black wire on the

dimmer.

• Connect the neutral wire to the white wire on the dimmer.

• Connect the lamp power (LOAD) to the red wire on the dimmer.

• The yellow wire is not used in single pole applications.

b. 3-way/multi-way wiring (Fig. 6)

NOTE: In a 3-way/multi-way circuit the TDA-603 must be used in

conjunction with the TDR (Touch Remote). The

TDA-603 does not work if used in conjunction

with standard 3-way/4-way switches.

NOTE: The dimmer can go in either location.

• Connect the green or non-insulated copper

GROUND wire from the circuit to the green wire on

the dimmer.

• Connect the power wire from the circuit (HOT) to the

black wire on the dimmer.

• Connect the neutral wire to the white wire on the

dimmer.