GHP Group Pleasant Hearth OFG467T Manual De Instrucciones página 14

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE. INTENDED FOR
RESIDENTIAL USE ONLY.
Use a glove when handling glass rocks.
Do not sit or stand on this table.
Keep children away during assembly. This item contains small parts which can
be swallowed by children.
Do not use indoors and inside any enclosure.
Retain the assembly instruction for future reference.
Installer — Please leave these instructions with the owner.
13. Use only 20-pound cylinders (approximately 18 ¼
inches high and 12 ¼ inches in diameter) equipped
with a cylinder connection device compatible with
the connection for the hose regulator supplied with
this appliance. Propane gas and cylinder are sold
separately.
The propane cylinder must be constructed and
marked in accordance with the specifications
for LP gas cylinders of the U.S. Department of
Transportation (DOT) or the standard for cylinders,
spheres and tubes for transportation of dangerous
goods and commission, CAN/CSA-B339.
A dented, rusted or damaged propane cylinder
may be hazardous and should be checked by
your cylinder supplier. Never use a propane
cylinder with a damaged valve connection.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
Never connect an unregulated propane cylinder to this appliance.
The cylinder must include a collar to protect the cylinder valve. The gas cylinder should not be
dropped or handled roughly.
The LP-gas supply cylinder must be disconnected when this appliance is not in use. Storage of
an appliance indoors is permissible ONLY if the cylinder is disconnected and removed from the
appliance. Cylinders must be stored outdoors out of the reach of children and must not be stored
in a building, garage or any other enclosed area. Your cylinder must never be stored where
temperatures can reach over 125°F / 51.5°C.
The maximum inlet gas supply pressure: 250 psi /1750 kPa. The minimum inlet gas supply
pressure: 5 psi /35kPa.
13
14
Standard 20 lb. tank