Prior To Commissioning - diversey TASKI ergodisc 1200 Manual De Instrucciones

Prior to commissioning

Insert a pad
Before inserting, please check:
• the pad for wear and cleanliness.
Attention:
Do not use worn or dirty pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• Stand behind the machine.
• Pull the adjusting lever at the ma-
chine handle and tilt the steel guide
bar upwards until it is completely up-
right.
• Release the adjusting lever to lock
the steel guide bar.
Notice:
Remove the product container before tilt-
ing the machine backwards.
• Tilt the machine backwards until the
machine handle is lying on the floor.
• Unscrew the fixation disc from the
pad holder.
• Place the pad centrally on the driving
disc and screw the fixation disc on
again.
Always tighten the fixation screw
very firmly, as otherwise the floor
may be damaged by the protruding
fixation screw.
• Put the machine slowly in a vertical
position again.
48
Application technique
Machine
Wet & base cleaning
Spray cleaning
Shampoo wet
Shampoo dry
Polish
Spray polishing
Grinding
Crystallization
Dosing:
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
Notice:
The correct dose is specified on the prod-
uct packaging and in the "TASKI Product
information sheet".
ergodisc 1200
no
no
no
no
yes
yes
no
no