Beginning Work With The Machine; End Of Operation - diversey TASKI ergodisc 1200 Manual De Instrucciones

Beginning work with the machine

Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this machine!
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
Cleaning start
• Insert the plug into the mains socket.
The display lights up.
• Hold the power supply cord in your hand.
Ensure that the power supply cord cannot come into con
tact with the tool.
• Hold the machine with both hands.
• Push the safety switch and operate
the operating lever at the same time.
The tool is activated.
• Cover the area in overlapping lanes.
Stairs
Notice:
The machine must only be transported
over stairs by two persons.
• Switch off the machine.
• Remove the plug from the mains socket.
Attention:
Lifting the machine can be dangerous un-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
• To lift the machine, one person grips
the machine at the machine housing
and the other person takes the ma-
chine handle.

End of operation

• Release the operating lever.
• Remove the plug from the mains socket.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
• Stand behind the machine.
• Pull the adjusting lever at the ma-
-
• Release the adjusting lever to lock
Notice:
Remove the product container before tilt-
ing the machine backwards.
• Tilt the machine backwards until the
• Remove the fixation disc from the
• Remove the pad.
• Screw the fixation screw back on.
• Put the machine slowly in vertical po-
chine handle and tilt the steel guide
bar upwards until it is completely up-
right.
the steel guide bar.
machine handle lies on the floor.
pad holder.
Always tighten the fixation screw
very firmly, as otherwise the floor
may be damaged by the protruding
fixation screw.
sition again.
EN
49