Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Components for the installation of the machine
The machine must be installed in compartments that are
460 mm high and between 560 and 568 mm wide. The
following installation components are supplied with the
machine.
1. Fixed support of the machine.
2. N°13 self-threading screws 3.9X19
3. N°1 fixed power cord
4. N°2 lateral guides
5. N°2 lateral 1-mm plates
6. N°2 lateral 2-mm plates
Installation of the machine
Position the fixed part provided
by resting it on the surface of
the furniture
Insert the side plates needed to compensate for any
empty spaces. The width of the compartment that
houses the machine is determined by the thickness of
the sides of the furniture. Four plates are supplied to
compensate for the different measures obtainable, two
that are 2 mm thick and two that are 1 mm thick. They
are used to compensate for the internal width of the
compartment to obtain an measurement of 562-560 mm.
Then mount the 2 guides
using the remaining 8
self-threading screws.
Insert the machine
by
matching
up
the guides with the
supports
already
mounted
in
the
compartment.
Slide it all the way in until the
safety stops click.
21
GB
Publicidad
Capítulos
Tabla de contenido
