Troubleshooting; Technical Data; Disposal - Amano American SANDERS AVAC12-P Manual De Instrucciones

PROBLEM
The main switch is not activated.
The plug on the machine's power cable has not been correctly inserted into the mains
socket.
The electrical specifications of the machine do not match the electrical specifications
of the power supply network.
The power cable is damaged.
The vacuum hose is not connected correctly to the nozzle on the collection tank.
The vacuum hose is not connected correctly to the extension hose.
The extension hose is not connected correctly to the vacuum accessory being used.
The vacuum circuit is blocked (vacuum hose; extension hose; vacuum accessory).
There is a blockage in the vacuum filters.
To dispose of the machine, take it to a demolition centre or an authorised
collection centre.
Before scrapping the machine, it is necessary to remove and separate out the
following materials, then send them to the appropriate collection centres in
accordance with applicable environmental hygiene regulations:
• Electric and electronic parts*
• Plastic parts (tanks and handlebars)
• Metal parts (levers and frame)
(*) In particular, contact your distributor when scrapping electric and electronic
parts.
This chapter lists the most common problems linked with the use of the machine. If you are
unable to resolve the problems with the information given here, please contact your nearest
assistance centre.
POSSIBLE CAUSE

TECHNICAL DATA

Electrical vacuum motor (voltage - frequency)
Number of vacuum motor
Vacuum motor rated power
Type of vacuum motor
Air flow rate
Suction vacuum
Total capacity of collection tank
Collection tank material
Length of power supply cable
Weight of the machine (without accessories)
Machine dimensions (lxpxh)
Sound pressure level (ISO 11201)
Protection rating
Hose length
Hose diameter

TROUBLESHOOTING

Press the main switch.
Connect the plug on the machine's power cable to the mains socket.
Check that the technical data on the machine's serial number plate match the data of
the mains supply.
Contact a specialised technician immediately.
Connect the vacuum hose correctly to the nozzle on the collection tank.
Connect the vacuum hose correctly to the extension hose.
Connect the extension tube correctly to the vacuum accessory being used.
Remove the obstruction in the vacuum circuit.
Clear the obstruction in the vacuum filters.

DISPOSAL

U.M
V
Hz
W
CFM
m /h
3
inH O
2
kPa
GAL
L
FT
M
LB
Kg
IN
CM
dB(A)
IP
FT
M
IN
MM
10
SOLUTION
AVAC12
120
50-60
1
1200
Double stage
131
224
88.4
22
12
46
Polyethylene
50
15
30.2
13,7
18x18x35.2
46X46X91
70
X4
25
7,5
1.5
40