I.SOUND DuraWaves Glow XL Guía De Usuario página 8

Connecting via audio cable (AUX in)
1. Pull up the protection cover of the DuraWaves Glow XL on
the back of the speaker
2. Plug one end of the included audio cable into the AUX port.
3. Power on the speaker by moving the power switch om
"OFF" to "ON".
4. Press and release the mode bu on and you will head a
voice say "AUX IN mode".
5. Plug the other end of the cable into your audio device.
6. Volume can be adjusted separately om your device or
the speaker.
NOTES:
• If you plug in an audio cable into the AUX port, but the
speaker is in Bluetooth mode, no sound will come om the
speaker when playing music.
• The speaker will start in the mode it was in when the speaker
was turned o . If the speaker is in a mode other than AUX IN
mode, press the mode bu on until you hear "AUX IN mode".
*Water Resistant Information & Warnings
IPX4 Water Level Rating
The DuraWaves Glow XL cannot be fully submerged under
water, but is resistant to water splashed om any direction. To
ensure the DuraWaves Glow XL prepared for use against
splashing water, remove all cables and tightly close the
protection cover that covers the charge port and AUX port,
otherwise water may seep into these ports and damage
the speaker.
Troubleshooting
Issue: My speaker doesn't turn on.
Solution: Try the following: