Retracting The Awning - Dometic PR2000 Instrucciones De Montaje

PR2000, PR2500
2. Fit the top end of the tension rafter into the attachment on the housing.
3. Slide the other end of the tension rafter into the attachment in the front panel.
7.3

Retracting the awning

A
NOTICE!
• Only retract the awning, when the fabric is free of debris (branches,
leaves or similar). Otherwise, the awning can be damaged when it is
retracted.
• Keep the awning free of dirt to prevent abrasions, stains and mildew.
• When retracting the awning, make sure that any branches or other
objects are not trapped in it.
1. Remove any debris (branches, leaves or similar) lying on the fabric.
2. Loosen the struts from the fastenings (pegs or latches on the vehicle).
Retracting the hand crank version
1. Click the top end of the hand crank into the holder in the awning.
2. Turn the hand crank until the awning is extended by only about 1.5 metres.
Position the struts vertically and back under the front panel every 30 cm so that
the awning stays secured at all times.
3. Fold the lever of the right strut down to loosen the struts.
4. Slide the struts together completely.
5. Fold the right strut up.
6. Turn the right strut into the front panel.
7. Slide the bottom part of the right strut into the latch of the front panel.
8. Retract the other strut in the same way.
9. Turn the hand crank until the awning is fully retracted.
10. Double-check that the awning is fully retracted before starting your journey.
The front panel should be right up against the housing.
11. Remove the hand crank from the holder on the awning.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
EN
Operating the awning
21