THERMEx Top Link Modul I Instrucciones página 70

70
THERMEX TOP LINK MODUL
INSTALLATION OF TRANSMITTER
The transmitter must be connected to the electrical current for the oven or hob. The transmitter is connected in accordance with the diagram:
Once the electrical current is connected, the green "Power" LED will light.
CONNECTION BETWEEN TRANSMITTER AND RECEIVER
Once the transmitter and the receiver are connected, the two devices must be paired to each other. One receiver can be connected up to a maximum
of five transmitters. The connection can be carried out in the following way:
1. Hold the "Pair" button on the Top Link transmitter down for about 3 seconds, until the green "Power" LED starts flashing.
2. Hold the button for connection to the receiver down for about 3 seconds, until the "indicator for connection" LED starts flashing.
3. Both the LED on the transmitter and the receiver will flash rapidly while the connection is being made.
4. When the LEDs light constantly instead of flashing, the connection is complete.
N
L1
L2
L3
Power output Power input
Fuse
Dipswitch
Diode - Power
ON DIP
Diode - Set 1
1 2 3 4
Button - Pair
Button - Set level
N
L1
L2
L3
M 536991200913062017