Initiation Of The System - Depuragua RO-50G-A01 Manual De Instalación Y Mantenimiento

MANUAL/NOTICE DÌNSTALLATION/MANUALE DI INSTALLAZIONE (MODELS RO A01 &E01)
3.4 Tank installation (image 5)
Cover screw tank with Teflon to avoid leakage. Attach the top tank valve.
Connect the osmosis membrane tube to the tank valve
The key of the tank should remain open to let the system accumulate water
3.5 Reverse osmosis unit.- (image 3)
The unit can be installed on the right or left the area under sink or on furniture. It is recommended
the right side for convenience. The installation in the basement is also an option, at a place near
the sink with water and access to the drain. The mounting location must allow an adequate
tolerance and accessibility to change cartridges. Connect the pipes fitted according to the color
scheme

7. INITIATION OF THE SYSTEM

Once the installation.
0 Make sure the membrane is in the porta membrane (part 9)
1 Open the supply of cold water (part 1)
2 Check the system for leaks.
3 Open the tap (part 18).
4 Plug the equipment to the mains
5 Check that wash (Part 13) key is closed
6 After a few minutes, the water begins to drip of the tap, let it drop for about 10 minutes, and close
the knob (item 18). It will take about 2 hours to fill the tank according to the local water
pressure. (Make sure that the tank (part 14) is open)
DO NOT DRINK WATER PRODUCED IN THE FIRST TANK.
7 When the tank is full (will know it because the pump stops), empty the tank by opening the
osmosis faucet until no more water comes out or very little
6 After complete discharge of water from the first tank, turn off the tap and wait for the tank to fill
again, repeat steps 6 and 7 once more.
8 The third tank is full, you can enjoy purified water.
9 Check that there are no leaks daily during the first week and periodically after the first week
10 You may detect some white turbidity in the water, this is due to air bubbles during the first week,
it is completely safe and normal. They will disappear over time.
6