Chapter 2. Transport And Installation - GALAGAR GAR CUT 2500 Manual De Instrucciones

CHAPTER 2. TRANSPORT AND INSTALLATION.

Knocks and sudden movements must be avoided when transporting the equipment. The equipment will
always be transported vertically. The packaging must be protected from water.
The GAR CUT (V. Industrial) equipment has lifting eyes. Preferably use this system.
IF A TRANSPALLET IS USED FOR LIFTING MAKE SURE THE EQUIPMENT IS STABLE.
1º
ROTATION
WHEEL
2.1 ELECTRICAL AND PNEUMATIC INSTALLATION.
The location must meet the following requirements:
- Place: Dry and ventilated, far enough away from the cutting area in order to prevent the metal dust caused
by the cutting process from getting into the equipment.
Electrical installation. Magnetothermal switch.
CUT 2500
40 A -230V 25 A -400V
Power supply hose (RVK-1KV).
CUT 2500
Length 230 V
2
10 m 6 mm
2
15-20 m 10 mm
Pos. 1
400 V
T
Pneumatic installation: Minimum capacity of the installation 250 l/min - 6 bar.
The pneumatic intake can be carried out directly from the compressed air circuit, although it is
recommendable, if the air contains a considerable amount of humidity or oil, for a gas pre-heater to be fitted
in the input. Thus we will avoid arc ignition failures as well as premature wear of the consumable elements
(electrode and nozzle).
GAR CUT (V. INDUSTRIAL). Instructions Manual
Wheels assembling.
CUT 4000/5000
63 A -230V 40 A-400V
CUT 4000/5000
400 V 230 V
2 2
6 mm 10 mm
2 2
6 mm 16 mm
The standard equipment leave the factory with the voltage selector at
400 V, in order to protect it against negligence in the connection.
230 V:
Pos. 2
1º. Place screw T in position 2.
230 V
2º. To connect the equipment place handle in 230 V. position
2º
DO NOT FORGET
400 V
CONNECTION
2
10 mm
INTO THE PLUG.
2
10 mm
FIXED
WHEEL
TO FIT THE
EARTH
16