Chapter 3. Start-Up. Adjustment And Operation Controls - GALAGAR GAR CUT 2500 Manual De Instrucciones

CHAPTER 3. START-UP. ADJUSTMENT AND OPERATION CONTROLS.

3.1 OPERATION CONTROLS. GAR CUT 2500.
E
R
I1
M
bar.
5,5-6
L1
A
L2
L4
GAR CUT (V. INDUSTRIAL). Instructions Manual
R
CN3
W
L3
CN3 - Output euroconnector for quick connection of cutting
torch. Safety cap.
W- Quick connector for earth cable.
R- Pressure reducing valve.
E- Pneumatic connection.
CN3 - Output euroconnector for quick connection of
cutting torch. Safety cap.
I1- ON/OFF switch (230/400V).
R- Pressure reducing valve.
M- Pressure gauge.
CN3
L1 - Green light indicating "ON" status.
L3- Amber light indicating equipment disconnected due
to overheating.
P1 - Cutting power selecting potentiometer.
L5 - Green light indicating cutting process.
L4 - Green light indicating pilot arc process (timed two
B
seconds).
L2 - Red light indicating equipment disconnected due to
lack of pressure.
P1
A)- ADJUSTMENT DIAL (NOZZLE ∅1.1 mm.) Possibility
of cutting with conctact nozzle. 50 A max.
L5
ADJUSTMENT DIAL (NOZZLE ∅1.3 mm.)
B)-
E
17