Setting Surface Controls; Size And Assembly Of Gas Burners; Sizes Of The Surface Gas Burners; Assembly Of The Surface Burner Heads, Burner Caps And Burner Grates - Sears Kenmore ELITE 790.4715 Serie Manual Del Usuario

Setting Surface Controls

Sizes of the Surface Gas Burners

Your appliance is supplied with
the following 4 different surface
gas burners:
• Simmer Burner (5,000 BTU)
• Standard Burner (9,500 BTU)
• Power Burner (11,000 BTU)
• Power Burner (17,000 BTU)
When setting up the range for the
first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
located as shown in Figure 1.
Grate
Pin
Burner
Grate
Burner
Cap
Cap Pilot
Hole
Burner
Head
Electrode
Orifice
Holder
Figure 2
Burner Cap
(Standard)
Standard
Burner Head
(9,500 BTU)
Electrode must be
located properly in slot
of each Burner Head
Extra Large
Burner Cap
Left Front
Orifice Holder
"POWER"
Burner Head
(17,000 BTU)
Figure 1
Assembly of the Surface Burner Heads, Burner Caps and
Burner Grates
It is very important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly
and at the correct locations.
1. Place all 4 Burner Heads in the correct locations (See Figure 1).
Make sure that the correct Burner Head is placed with the
corresponding Orifice Holder and that the Electrode is located
properly in the slot of each Burner Head (See Figure 2). Proper Burner
Head placement insures that each Burner will have the correct spark
required for surface gas ignition.
2. Place the correct Burner Caps at each of the burner locations (Burner
Cap Pilot Hole must face up). Each of the 4 (four) Burner Heads
MUST have a Burner Cap installed to insure proper ignition and gas
flame size and must be in place with the Pilot Hole facing up
BEFORE placing the Burner Grates (See Figure 2).
3. Place the 2 (two) cast iron Burner Grates supplied with the range.
Carefully line-up the 2 Grate Pins on each Grate with the Cap Pilot
Holes in the 2 Burner Caps on each side of the range. DO NOT force
the Burner Grates onto the Burner Caps. Forcing the grates down
onto improperly installed Burner Heads and Burner Caps may damage
the gas burners. Each Burner Cap is designed with a Cap Pilot Hole
in the top center of the Cap. Visually check that ALL the Grate Pins
line up into the Burner Cap Pilot Holes (See Figure 2). Properly
installed Burner Grates will rest with all four Grate legs on the glass
cooktop.
REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.
8
Large Burner Cap
"POWER"
Burner Head
(11,000 BTU)
Left Rear
Orifice Holder
Burner Cap
"SIMMER"
Burner Head
(5,000 BTU)
Right Rear
Orifice Holder
Right Front
Orifice Holder
Small