Hilti TE 50-AVR Manual De Instrucciones Original página 30

5.2.1 Drilling with hammering action (hammer drilling)
1. Set the function selector switch to the "Hammer drilling" position
2. Press the drill bit against the work surface.
3. Press the control switch.
◁ The product starts.
5.3 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel
positioning". Turn the function selector switch until it engages in the
"Chiseling" position.
Note
The chisel can be adjusted to 24 different positions (in 15° increments).
This ensures that flat chisels and shaped chisels can always be set to
the optimum working position.
1. Set the function selector switch to the "Chisel positioning" position
2. Rotate the chisel to the desired position.
3. Turn the function selector switch until it engages in the "Chiseling"
position.
◁ The product is ready for use.
5.3.1 Chiseling 8
▶ Set the function selector switch to the "Chiseling" position
5.3.2 Switching sustained operation on and off
Note
When chiseling, the on/off switch can be locked in the "on" position.
1. Push the lockbutton for continuous operation forward.
2. Press the on/off switch as far as it will go.
◁ The product then runs in sustained operating mode.
3. Push the lockbutton for continuous operation back.
◁ The product switches off.
24 English
Printed: 15.09.2017 | Doc-Nr: PUB / 5283607 / 000 / 02
7
6
.
9
.
.