Scan Mode - Leica GEOVID HD-B Instrucciones

SCAN MODE

61
72
38
The Leica Geovid HD-B binoculars can be used to
measure continuously (scan mode).
Hold down the main / release button (7) on the 2nd
press.
After around 2.5 seconds, the binoculars switch to
scan mode and then carry out measurements
continuously. This can be seen by a change in the
65
display:
Around every 1s a new measured value is shown.
Scan mode is particularly practical for measuring
small and moving targets.
Notes:
• In scan mode, the
displayed until after the last measurement.
• Because of the continuous measurements, power
consumption is greater in scan mode than for single
measurements.
correction value is not
AbC