Polaroid INSTA-SHARE Moto Mod Manual Del Usario página 3

Load paper into your Insta-Share Printer
You'll need to remove the back cover to insert printer paper.
Remove the back cover
1 Press down on the cover and slide it partially off.
2 Lift off the cover.
Insert the paper
Note: Use only Polaroid ZINK® Zero-Ink® Printing Technology 2" x 3" paper in your Insta-
Share Printer or else it may not print correctly.
1 Insert the blue piece of paper with the barcode side facing down.
Note: the blue piece of paper cleans and sets up the printer. You must use the blue
sheet of paper that came with that pack each time you open a new pack of paper.
2 Insert the white paper with the ZINK logo facing down.
Note: put all ten sheets into the printer, but no more than one pack at a time.
Because ZINK paper is heat-activated, protect it from heat and moisture by leaving
the paper in the foil pack until you're ready to load it into your printer
1
.
1
2