Taurus APLATEC AC 293 Manual Del Usario página 24

between 3~24h of timer, up/down adjustment
once changes 1h.
- When the set time expires, the air conditioner
turns off automatically
2. Setting timer on
- When the air conditioner is in standby state,
press TIMER, the timer LED lamp is on, and
meanwhile 88 Nixie tube will flicker " " for 5 times,
at the moment press UP/DOWN to adjust the
desired time, and the method of adjustment is the
same as that during timer off.
- During setting of timer, the operating modes
after start can be selected, if COOL mode is
selected, the set temperature can be adjusted
simultaneously.
- If DEHUMIDIFY mode is selected, the set
humidity can be adjusted simultaneously.
- After the set time expires, the air conditioner
starts automatically and runs in the selected
operating mode.
3. Change of the set time
- In the running process of timer, if you are
intended to change the existing timer, you can
press TIMER once, at the moment 88 Nixie tube
will flicker and display the remaining time, during
flicker pressing UP/DOWN can increase/decrease
time on the basis of the original time.
-If you press TIMER again during flicker, the set
time will be cancelled, namely timer quits.
Swing
- Press this button to control the movement of the
louver.
Cooling mode:
- Press mode to select cooling mode, cooling
mode indicator turns on.
- Press Up or Down to adjust temperature in a
range of 18~30ºC (64~86ºF).
-When the up or down is pressed once,
temperature will go up or down by 1ºC or 1ºF
every time.
- Press speed to select high, mid or low fan speed.
Fan mode:
- Press mode to select fan mode fan indicator
turns on.
- Press speed to select high, mid or low speeds.
- In that mode, press Speed for 5 seconds to
run the internal dry function, i.e. both upper and
lower fans work simultaneously. Press Speed
for another 5 seconds to cancel the internal dry
Notice AC 293.indb 24
function.
- Temperature is not adjustable.
- Press Swing to turn off or turn on the up/down
swing function.
Dehumidifying mode:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Temperature and speed are not adjustable.
- Press Swing to turn off or turn on the up/down
swing function.
Sleeping mode:
- After selecting Cool mode, press Sleep on
remote control (or press up and timer on operating
panel simultaneously) to enter Sleep mode, both
upper and lower fans are forcibly set at LOW
speed.
- In approximate 7h the air conditioner turns off
automatically. If SLEEP is to be cancelled, press
SLEEP again or conversion modes to cancel the
sleep function.
- Press SWING to turn off or turn on the swing
function.
- Sleeping mode is invalid under dehumidifying
and fan mode. Under water full, machine standby
and mode conversion, sleeping mode will be
cancelled
Compressor protection:
- Three minutes later after power on / restart,
compressor starts to run.
Water tank full protection:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
- Please discharge water in the machine according
to chapter "water drainage".
Water drainage:
- When the inner water tank is full, its indicator will
flash on the screen.
- The appliance enters into standby mode.
- Pull out the plug to drain out water, power off
the machine and restart it , the machine will runs
normally .
-This model have self evaporative function,
under cooling mode, please do not use continue
drainage to get better cooling effect.
Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
22/01/2016 14:25