Back Panel View - Chauvet VIP DRIVER Guía De Referencia Rápida

VIP™ Driver QRG

Back Panel View

Back Panel
Connections
2. Link
Output
1. DIP Switches
3. Link
Input
Disconnect power before connecting other equipment to the VIP™ Driver.
Number
DIP Switches - assigns the address for up to 4 VIP™ Drivers.
You will identify each VIP™ Driver sender address within the
LED Studio software application.
Note: The VIP™ Driver is the sender, and the panels are the
receiver(s).
1
Link Output - can be used to connect to the next VIP™ Driver.
2
Use a 9-pin D-Sub serial cable for connection (included).
Link Input (don not use if #1) - connection from the previous
3
VIP™ Driver. Use a 9-pin D-Sub serial cable for connection.
U–Main Out - is the primary etherCON® signal output that
4
connects to the first VIP™ in a series.
Video Signal LED - indicator flashes green when the video
5
connection signal is being received by the VIP™ Driver.
Power LED - indicator displays red when power is being
6
received by the VIP™ Driver.
5. Video
Signal LED
7. D-Backup Out
4. U-Main Out
6. Power
LED 8. USB Data In
Description
4
9. DVI-I Video In
11. Power Switch
10. HDMI Video In
12. Power In
EN