Handling And Storage - Drive 14001E Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning
In this section, we describe the procedures to clean and decontaminate the pump and bubble
pad. It is important to follow these procedures before using the system on patients.
The cleaning task is required at least once a week to maintain personal hygiene.
Pump
 DO NOT immerse or soak the pump.
 Check for external damage and move the pump to a cleaning area.
 Place the pump on a work surface and spray or wipe the outside of the case with
quaternary ammonium solution.
 DO NOT spray any cleaning solution directly on the surface of the pump.
 DO NOT use a Hypocarbonate or Phenolic based cleaning solution as this may cause
damage to the case. Allow the solution to incubate for 10 minutes or accordingly as
stated by the cleaning product used.
 Spray cloth with cleaning solution and clean faceplate. DO NOT allow excess cleaning
solution on faceplate or control panel. (If solution gets inside, damage will occur.)
Allow surface to thoroughly dry after cleaning.
 After the pump is thoroughly cleaned and dried, proceed to plug in the pump and test to
see if it runs normally.
Bubble Pad
 Any obvious blood spots should be cleaned thoroughly with 1:9 Hypochlorite solution
(1 part bleach to 9 parts water) and allow drying for at least 10 minutes. Then blot with
a clean, damp cloth.
 Brush or wipe down all surfaces with soap and water before applying any liquid.
 Allow it to thoroughly air dry. Once the inside is dry, turn it back: wipe down the outside
of the bag with disinfectant.
 Dry the bubble pad away from direct sunlight after cleaning.

Handling And Storage

 Lay the bubble pad flat. Fold or roll it carefully.
 Unplug the pump and store with proper identification tag.
 Follow the national requirement to dispose the pump.
Maintenance
 Check the power cord and plug to see if there are abrasions or excessive wear.
 Plug in the pump and check the airflow from the hose connection port. The airflow
should alternate between ports every half-cycle time.
7
REV6.12.11.14

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

14001efd14002e

Tabla de contenido