Publicidad
Idiomas disponibles
Idiomas disponibles
DO NOT FILL THE FUEL TANK WITH GASOLINE THAT DOES NOT HAVE OIL MIXED IN IT.
SHAKE THE GASOLINE CONTAINER BEFORE EACH FILLING OF THE FUEL TANK.
Oil
(I/2 cup or 3,2 oz.)
Shake Can
Gasoline
!
(1 u.s.
!
+
1 UoS,gallon container
IMPORTANT:
Do not use outboard motor
oil or automobile
oils, such as SAE 30 oil,
or multi-viscosity
oits, such as 10W-30 or
1oW-40.
• Reinstall the cap on the gasoline
container and shake conlainer
vigorously
so the oil mixes with the gasoline
° Add an additional 3 U.S. quarts of
gasoline to the gallon container and
shake the container again.
WARNING:
Gasoline is flammable
and
caution must be used when handling or
storing it. Do not fill fuel tank while snow
thrower is running, hot, or when snow
thrower is in an enclosed area. Keep away
from open flame, electrical spark, and do
not smoke while filling the fuel tank. Never
fill fuel tank completely;
but fill the tank to
within 1/4-1/2 inch from the top to provide
space for expansion of tuel. Always flit fuel
tank outdoors and use a funnel or spout to
prevent spilling. Make sure to wipe up any
spilled fuel before starting the engine. Store
gasoline in a clean, approved container,
and keep the cap in place on the container.
Keep gasoline in a cool, well ventilated
place; never in the house. Never buy more
than a 30 day supply of gasoline to ensure
volatility° Gasoline
is intended 1o be used as
a fuel for internal combustion
engines;
therefore, do not use gasoline for any other
purpose. Since many children like the small
of gasoline, keep it out of their reach
because the fumes are dangerous
to
inhale, as well as being explosive.
TO STOP
ENGINE
• To stop the engine, turn the key to OFF
and remove key. Keep key in a safe
place. The engine will not start without the
key. See figure on next page.
TO START
ENGINE
(RECOIL
START)
Before starting the engine, be certain that
you have read and understood
all the
instructions
on the preceding pages.
COLD START
Insert the key and turn ON.
Move the choke control to the FULL
position.
Push the primer button while covering the
vent holes as follows: (Remove finger
from primer button between primes).
Do not prime if temperature
is above
50°F.
Two times if temperature is 50 ° F to t5°F.
Four times if temperature is below 15°Fo
• Pull the starter handle with a smooth rapid
movement.
Do not allow the starter rope
to snap back. Rewind smoothly while
holding the starter handle. If the engine
fires but does not start, pull the starter
handle until the engine starts_
• After three pulls, repeat the priming and
pulling steps again.
• As the engine warms up and begins to
operate evenly, move the choke control
slowly to the OFF position. If the engine
falters, return to i/2 choke until it runs
smoothly, then move to OFF position.
NOTE:
Allow engine to warm up for a few
minutes before using snow thrower, as the
engine will not develop full power until it
reaches operating temperature_
WARM START
o Be sure the choke is in the OFF poSi-
tion and pull the siarter handle until the
engine starts.
Publicidad
